3DR 100MW/500MW Radio Telemetry 433Mhz 915Mhz Air and Ground Data Transmit Module with OTG cables for APM 2.8 /Pixhawk 2.4.8

شناسه محصول: 32955741883 دسته:
عکسها ،توضیحات و مشخصات این محصول به صورت سیستمی عینا از سایت Aliexpress چین درج شده است و در صورت ثبت سفارش، پس از خرید از علی اکسپرس ، از چین به آدرس شما ارسال می شود.

360,000 تومان | 3,240,000 تومان


نقد و بررسی اجمالی
  • برند: TEAEGG
  • Material: Composite Material
  • Tool Supplies: Battery
  • Upgrade Parts/Accessories: 3DR RADIO
  • RC Parts & Accs: Transmitters
  • Use: Vehicles & Remote Control Toys
  • Technical parameters: Value 6
  • مدل: 3DR RADIO
  • Remote Control Peripherals/Devices: Remote Controller
  • For Vehicle Type: Airplanes
  • Four-wheel Drive Attributes: Assemblage
  • Wheelbase: Bottom Plate
We have tested the radio telemetry and can connect normally. We have uploaded the firmware. Please do not upload the firmware. Different firmware will cause the firmware to be incompatible. Please do not modify the parameters. Wrong parameters will prevent the connection.
433Mhz / 915Mhz frequency channel transparent serial interface, data rate up to 250kbps, antenna range about 1 miles. 
Adaptive time-division multiplexing. 
Supports LBT and AFA, configurable duty cycle, built-in error correction codes (which can correct data errors up to 25%). 
Adaptive control of HopeRF HM-TRP radio AT radio module based on open-source firmware configuration command for RT command and APM radio remote configuration when used together with SiLabs, Si1000 RF micro controller. 
Due to the light and screen setting difference, the color of the item may be slightly different from the pictures. 
Please allow slight dimension difference due to different manual measurement. 
Wifi Telemetry can be used for PIXHAWK or APM flight controller,it is same as 3DR radio telemetry.

Radio V5 Telemetry is new type, Either one can be used as ground or air terminal

Package included:
1 x 915mhz / 433Mhz Telemetry Kit
2 x Connecting Lines  
2 x Round Bar Antennas  
1 x OTG Cable

How to use Radio Telemetry For PIXHAWK flight controller?

1.use 6P line connects to pixhawk flight controller.

Due to the different firmware, some firmware, two ports can be used, some firmware can only use one of the ports. So find one of the available ports for the connection.

IF you use PX4 firmware ,only TELEM1 can be used ,can not use TELEM2.

IF you use ardupilot firmware, find one of the available ports for the connection.

2.Please note:

  1. When using Radio Telemetry connection, it must use 3DR Power Module or 5V ESC to supply power to the flight control. USB cannot be inserted because USB priority is higher than Radio Telemetry . If USB cable is plugged in, it cannot be used for radio telemetry transmission.
  2. The default baud rate of the Radio Telemetry is 57600, not 115200. Select the correct COM port and do not select AUTO.
  3. If there is a driver problem, download from here:pix.rctoysky.com/CP210x_VCP_Windows.rar